Connection of Elduino CAN128 V1.0

This is a short description of the connections on Elduino CAN128 board.

Elduino CAN128 V1,0 connections

 

CAN bus
K1 – Two wire CAN bus connector. 
P16 – Jumper connects the terminating resistor (120R) to the CAN bus. Do not mount it when you connect it to the car.
 
 LIN bus
K2 – LIN bus connector. Pin BAT has to be connected to +12V from external power supply.
P18 – LIN bus master/slave selection. If mounted, Elduino board is master on the LIN bus. If taken off – it is a slave.
 
For debugging
P17 – two additional GROUND pins. For easy voltage/signal measurement with oscilloscope, multimeter or logic analyzer.
JP1 – selects the microcontroller and board I/O voltage levels (3,3V or 5V). Please allways set it to 5V (two lower pins are shorted).

Comments

Comment: 
Hi Vaidas, is it possible to change voltage level to 3.3v? why i'm asking, you mentioned that it should set to always to 5v.   
By Farman (not verified)

Comment: 
It is possible to change voltage level to 3,3V, however this puts microcontroller outside its specifications. The microcontroller is clocked at 16MHZ and according to the datasheet microcontroller should be powered from 5V with this clock frequency. I did not have problems running the microcontroller at 3,3V and 16MHZ, but it is not a reliable and recommended solution. Also, when running microcontroller at 3,3V you have to make sure that you do not connect 5V level signals to it.
By gassrini

Add new comment

Filtered HTML

  • Web page addresses and e-mail addresses turn into links automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <blockquote> <code> <ul> <ol> <li> <dl> <dt> <dd>
  • Lines and paragraphs break automatically.

Plain text

  • No HTML tags allowed.
  • Web page addresses and e-mail addresses turn into links automatically.
  • Lines and paragraphs break automatically.
CAPTCHA
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.
Please prove you are not a robot:
Question text provided by textcaptcha.com